giglamesh Posted July 8, 2009 Report Share Posted July 8, 2009 when using a sensor mask (the circle that all the other sensores are connected to. do you have to use trial and error to get the perfect positioning, or do you just set it to x and y of the top of the character (or something like that)? thanks in advance Link to comment Share on other sites More sharing options...
Asuma Posted July 8, 2009 Report Share Posted July 8, 2009 I start off by doing this. After that. I go into the event editor and create a new "Always" event. Then under one of the sensors, I right-click and hit "Set Position". Next, I click on the sensor, type 0,0 in the X and Y boxes. After that I click on the mask. It should give you distance from the point of the hotspot from your mask to your sensor. Link to comment Share on other sites More sharing options...
Recommended Posts